C4 mask CONDOR Carbon Antifog

C4 mask CONDOR Carbon Antifog

The Condor mask by C4 is designed and developed for peak performance in any type of diving: freediving, spearfishing, snorkelling or scuba diving. Its unprecedented field of view sets a record by itself. It finally brings to the market what we have all missed - a practically unobstructed view upwards, so no more neck pain!

Now standard with a new anti-fog technology. C4 puts an end to the problem of fogging in diving masks by introducing several models equipped with special films applied to the inside of the lenses. These films prevent fogging in any situation, as long as a few simple usage guidelines are followed. There is no need for you to burn the lenses of the mask or use toothpaste to prepare it for diving. No need for spitting or use anti-fog sprays or sticks either. Just put the mask on and dive fog-free! All you have to do to maintain this is to wash the mask with mild detergent after each use to remove any oily substance. 

The Condor Mask won the award for best Mask on the market at the International Award 2024 by Apnea Passion Magazine.

Instructions for Use and Maintenance of Antifog Masks

Introduction

The lenses of any mask – with or without antifog treatment – may fog up if they are dirty or not properly cleaned.

Masks with antifog treatment are designed to eliminate the need for the initial preparation normally required for all new masks. This treatment removes residues of oils and silicone greases used in the molding of silicone skirts. These residues are the main cause of fogging and are often difficult to remove even after multiple cleanings.

It is important to highlight that antifog masks are equipped with internal films applied directly to the glass, which constitute the antifog system itself: these films must never be removed, scratched, or tampered with, as doing so would compromise the effectiveness of the treatment.

It is important to note that an antifog mask can still fog up if the internal surfaces are not properly maintained.

Usage Recommendations

Preventing lens contamination
• Avoid contact with greasy or oily substances (e.g. sunscreens, oils).
• Never touch the inner lenses with dirty or dry fingers.
• Pool water may leave stains or residues depending on the chemicals present.
• The most common contamination, especially in summer, comes from sunscreen.

1. 1. Managing temperature differences
      • Temperature variations between the inside and outside of the mask may cause condensation.
      • To reduce this effect, wet both your face and the mask before use to equalize the temperature.
      • Typical situations:
      • swimming pools with warm water and very humid environments,
      • sea dives with hot air and relatively cool water.
   2. Cleaning the inner lenses
      • Clean the inner lenses before each use.
      • If cleaning is performed regularly and dirt is minimal, rinsing with running water is sufficient.
      • In case of persistent dirt:
      • carry out a preliminary cleaning with a non-greasy detergent diluted in fresh water (e.g. neutral liquid soap or dishwashing liquid), or
      • use a mask-specific product such as Absolute Cleaner or Antifog.
      • Other antifog products may also be effective, but their performance has not been verified and therefore cannot be guaranteed.
      • As an alternative, the traditional method of applying saliva followed by rinsing immediately before use remains valid.